Coming soon

Fly-in tie-down kit

Three screw-in anchors, three ropes and a bag for dirt and turf, plus an add-on for rock: a small cordless rotary hammer, removable anchors and the printed cases that keep it together.

Not a rated or certified system. How well any anchor holds depends on the soil or rock it is set in, how deep and at what angle it goes in, and how wet the ground is. The numbers anchor makers publish are for set conditions, usually average soil or test concrete, not your strip. We have not load-tested this kit. Use it as one part of good judgment: park into the wind, use all three tie-down points, check the ropes before dark, and move or stay with the airplane if weather is coming.

Soft ground set (RL-CG-200)

For dirt, turf and firm sand. Helical screws turn in by hand with the drive bar through the eye, and come out the same way, leaving a small hole and no hardware behind. In loose sand, skip the screws and bury a deadman instead; the bag doubles as a sand bag.

ItemWeightBasis
Helical ground screws, 16 to 18 in, x32,460 gEstimate from published weights of 16 in steel and 18 in aluminum screws (650 to 820 g each); budgeted at the heavier one
Drive bar for the screw eyes, aluminum150 gEstimate
Tie-down rope, 3/8 in polyester, 12 ft, x3650 gEstimate from typical 3/8 in double-braid weight
Ridgelift rope keepers, x387 gSlicer estimate, 29 g each
Roll-top bag, heavy nylon250 gEstimate
Total3,597 g (7.9 lb)

Add the printed chocks (about 488 g a pair) if you want them in the same bag.

Rock add-on (RL-CG-210)

For ledge and solid rock where nothing screws in. Drill a 12 mm hole about 65 mm deep, blow it clean, set a removable expansion anchor, and tie to it. When you leave, the anchor comes out by hand and goes back in the caddy. Plain stainless pins in drilled holes, angled away from the load, are a cheaper and heavier backup.

ItemWeightBasis
12V SDS-Plus rotary hammer with one battery2,087 gPublished: one 12V model is 3.7 lb bare and 4.6 lb with battery
12 mm SDS-Plus four-cutter bits, x2180 gEstimate
Hole brush and blow-out bulb90 gEstimate
12 mm removable expansion anchors with hanger, x3420 gPublished: 140 g each for one stainless model
Steel quick links or locking connectors, x3240 gEstimate
Ridgelift bit case (body and cap)198 gSlicer estimate
Ridgelift anchor pin caddy158 gSlicer estimate
Safety glasses and ear plugs40 gEstimate
Total3,413 g (7.5 lb)

Both sets together come to about 7.0 kg (15.5 lb) on our budget. Published weights for three-anchor portable kits run from about 5.4 to 10 lb, so the soft ground set alone is in the same range; the rock add-on is the extra.

Before you drill anything

  • Many places do not allow it. In National Forest wilderness, motorized equipment is prohibited (36 CFR 261.18), and BLM wilderness has the same kind of rule (43 CFR 6302). A cordless drill counts.
  • A drilled hole is permanent. On private and state strips, ask the owner or manager first. Use an existing tie-down when there is one.
  • Pick solid rock away from edges, cracks and loose flakes. Rock is not test concrete, and the published anchor numbers are for concrete.
  • Wear eye and ear protection, and keep the battery's terminals covered and the battery protected in the airplane.

What is still open

  • Which screw anchor and which removable anchor we carry, after we try the candidates ourselves.
  • Price. The kit depends on hardware we do not make, so it is priced once suppliers quote.
  • Whether the rotary hammer is sold in the kit or listed as a separate item you may already own.

More detail in the guides: tie-downs by ground type and drilled rock anchors.

Coming soon. Not for sale yet: there is no checkout for this item.

Get word when the gear is ready.

One waitlist for the whole shop. No payment and no deposit.

Free. No payment and no deposit. News only, and every email we send has an unsubscribe link. If the signup service cannot be reached, this opens a message to hello@ridgeliftaero.com for you to send. See the Privacy Policy.