Buyer's guide

Tie-downs by ground type

Most portable tie-downs are sold as working in any soil. In practice the ground decides, and the right answer on a gravel bar is different from the right answer on a grass strip.

Field notes coming. This guide is built from makers' published specs and listings. We have not used these products on a trip yet, so there are no test results or ratings here. Where a number appears, it is the maker's number, with the source listed at the bottom.

What an anchor has to do

A tie-down keeps a parked airplane from lifting a wing or weathervaning in a gust. The load comes up the rope at an angle, so an anchor holds by bearing on undisturbed soil around and above it. Anything that loosens that soil, like water, sand with no structure, or a hole that was enlarged while setting the anchor, cuts the holding power.

The FAA's old advisory circular on tie-downs, AC 20-35C, Tiedown Sense, has since been cancelled, but it is still a clear read on rigging ropes: secure, with a little slack, and knots that hold.

The main types

Screw-in (helical) anchors

A steel or aluminum helix you turn in by hand with a bar through the eye, or with a socket. Good in firm dirt and turf, and they come out clean. They stop at roots and buried rock, and they spin out of loose sand. One listed 16 in steel kit gives 500 lb per anchor and says results vary by soil; one 18 in cast aluminum screw weighs 23 oz and installs with a 1 in socket or an impact driver.

Angled spikes through a hub

Three spikes driven at angles through an aluminum hub, so the spikes pull against each other. Fast in dirt and frozen ground, and they handle small rocks better than a screw. Two kits of this type list 3,600 lb combined for three hubs, at about 8 lb a kit.

Driven earth anchors

A small aluminum anchor on a wire rope, driven down with a rod and then pulled back so it turns sideways and locks. Strong for their weight: one maker lists 300, 1,100 and 3,000 lb in average soil for its three smallest sizes. They are usually left in the ground, so they suit a private strip with the owner's agreement more than a public one.

Buried deadmen

A bag of sand, a log, or a plate buried and tied off, with the rope coming up at an angle. The answer for loose sand and snow. Slower to set, nothing to buy except a bag and a shovel.

Drilled rock anchors

A hole drilled with a cordless rotary hammer and a removable expansion anchor or a steel pin. The only portable option on ledge. It has its own guide: drilled rock anchors.

Choosing

  • Think about the strips you actually use. If they are mostly grass and dirt, screws or spikes. If you camp on river bars, carry a deadman bag too.
  • Count the weight. Published kit weights run from about 5.4 to 10 lb. That is a real share of a light airplane's baggage allowance.
  • Practice at home. Setting an anchor in the dark in a rising wind is the wrong time to learn it.

Published specs for each kit are in the table on the tie-downs page.

Sources

Specs read from these pages on November 14, 2026. Makers change specs; check the current listing before you buy. Retailer links on this site are placeholders for now. If we add paid links later, each one will be marked.

Questions and answers

Which tie-down works in sand?

Screws and short spikes tend to pull out of loose sand. A buried deadman, such as a bag filled with sand and buried with the rope coming up at an angle, is the usual answer.

Do published holding numbers apply on my strip?

Not directly. Makers rate anchors in set conditions, such as average soil. Wet, loose or rocky ground can hold much less. The only way to know an installed anchor's capacity is to proof-load it.

Have you tested these kits?

Not yet. This guide is built from published specs. Field notes will be added after we use them on trips.