Coming soon

Printed Wheel Chock

A light chock with a curved face, printed in a high-visibility color, with a bore for the rope that joins the pair.

Render of the Printed Wheel Chock in its print orientation.
Rendered from the CAD model, in the orientation it prints.

Every strip has a slope somewhere. The chock is a simple wedge with a curved face that sits against the tire, a rounded body that does not chew up the tire, and a bore through its length for a rope that joins the pair so one does not get left behind.

It prints standing on its end with no supports. The orange color is so you see it before you taxi.

$49 (pair), coming soon

Coming soon. Not for sale yet: there is no checkout for this item.

Part number
RL-CG-104
Size
105 x 60 x 120 mm each
Fits
Tires on light airplanes. The 60 mm height suits smaller tires; a taller version for large low-pressure tires is one setting in the CAD file.
Material
PETG or ASA, 35 percent infill
Printed mass
About 244 g each (slicer estimate)
Print time
About 10.2 h each on one printer (slicer estimate)
Supports
None
Made in
Onalaska, Washington

Limits

  • Chocks hold a parked airplane with the engine off. They are not wheel stops for run-ups.
  • Printed chocks are lighter than rubber or aluminum ones and have not been load-tested yet. Treat them as a light-duty chock until we publish numbers.
  • Not tested in the field yet. Field notes and any load numbers will be added here when we have them.

Get word when the gear is ready.

One waitlist for the whole shop. No payment and no deposit.

Free. No payment and no deposit. News only, and every email we send has an unsubscribe link. If the signup service cannot be reached, this opens a message to hello@ridgeliftaero.com for you to send. See the Privacy Policy.