Coming soon
Fuel Tester Holster
Carries a cup-style fuel sampler on a belt or bag strap, with a drain hole and a window so you can see it is there.

Most of us end up with the fuel sampler in a door pocket, a shirt pocket, or on the ground beside the wheel. The holster gives it one place to live during the walk-around and while you are camped.
The sampler drops into a sleeve with a small drain hole at the bottom, so the last few drops run out instead of sitting in the plastic. A slot in the front shows at a glance whether the sampler is in it. Two strap slots in the back plate take a belt, a pack strap, or a cargo strap up to 1 in wide.
$24, coming soon
Coming soon. Not for sale yet: there is no checkout for this item.
- Part number
- RL-CG-101
- Size
- 58 x 49 x 95 mm
- Fits
- Cup-style samplers up to 36 mm across (set in the CAD file). Straps up to 26 mm (1 in) wide.
- Material
- PETG or ASA
- Printed mass
- About 70 g each (slicer estimate)
- Print time
- About 2.0 h each on one printer (slicer estimate)
- Supports
- None
- Made in
- Onalaska, Washington
Limits
- It holds the sampler. It is not a fuel container. Wipe it dry and keep it out of the cabin if it smells of fuel.
- Sampler sizes vary a lot. Measure yours; the bore is one number in the CAD file and we can print other sizes.
- Not tested in the field yet. Field notes and any load numbers will be added here when we have them.
Other printed parts
-
RL-CG-102 · Coming soonTie-Down Rope Keeper
A flat winder for one tie-down rope, with a jam slot for the tail and a hang hole.
-
RL-CG-103 · Coming soonCover Keeper Clip
Snaps onto a 1 in tube and holds the lanyards of a pitot cover and plugs, so they stay together when they are off the airplane.
-
RL-CG-104 · Coming soonPrinted Wheel Chock
A light chock with a curved face, printed in a high-visibility color, with a bore for the rope that joins the pair.
Get word when the gear is ready.
One waitlist for the whole shop. No payment and no deposit.