Coming soon
Wing Tarp Pole Cap
A wide cap for the end of a tent pole that holds a tarp grommet at the outer edge of a wing shelter.

A tarp off the wing makes a dry kitchen and a place to sit out of the sun. The outer edge needs poles, and a bare pole tip pushed through a grommet wears a hole in the tarp.
The cap fits over the pole end, puts a 60 mm platform under the tarp, and has a short pin for the grommet. The 45 degree flare under the platform is what lets it print with no supports.
$26 (pair), coming soon
Coming soon. Not for sale yet: there is no checkout for this item.
- Part number
- RL-CG-108
- Size
- 60 x 60 x 69 mm
- Fits
- Poles 12.5 mm (1/2 in) across, 28 mm socket. Tarp grommets that take a 6.4 mm (1/4 in) pin.
- Material
- PETG or ASA
- Printed mass
- About 33 g each (slicer estimate)
- Print time
- About 1.2 h each on one printer (slicer estimate)
- Supports
- None
- Made in
- Onalaska, Washington
Limits
- The cap goes on the outer poles, away from the airplane. It never touches the wing.
- Tie the tarp to the airplane only where the airplane is built to take a line, such as tie-down rings, and keep tension light. Wind on a tarp is a big load.
- Not tested in the field yet. Field notes and any load numbers will be added here when we have them.
Other printed parts
-
RL-CG-101 · Coming soonFuel Tester Holster
Carries a cup-style fuel sampler on a belt or bag strap, with a drain hole and a window so you can see it is there.
-
RL-CG-102 · Coming soonTie-Down Rope Keeper
A flat winder for one tie-down rope, with a jam slot for the tail and a hang hole.
-
RL-CG-103 · Coming soonCover Keeper Clip
Snaps onto a 1 in tube and holds the lanyards of a pitot cover and plugs, so they stay together when they are off the airplane.
Get word when the gear is ready.
One waitlist for the whole shop. No payment and no deposit.